With proper connections you can use the Push Pull interface to replace true open collector circuits by using an external diode connected in a way to limit the direction of the current for RS422 (TTL) circuits provide a constant 5 V signal level that is not dependent on the supply voltage. Two supply voltage ranges can be selected: From 4.75 to 5.5 VDC (can be used to replace open collector output drivers) or from 8 to 30 VDC. Using differential signals the output fully complies to the RS422 standard.
The differential outputs have the highest frequency response capability and the best noise immunity. To ensure this the receiver should also be a differential.
Replacement of Older Output Drivers
Servo motion controller
DC garage door motor
Brushless dc motor
1. Quick response once received customer’s quotation query
2. Professional engineer team, to solve your problems at any time
3. Strictly inspection before shipment
4. Various encoder models to be selected
5. Short lead time
6. High quality standard
R85mm(spring plate 158T170)
DC5V ; DC8-30V
Cable out from side
line drive (26LS31) TTL
line drive(DC8-30V) HTL
Top response frequency
About 1800g (with package)
Each single encoder is packed into a single safe carton with protecting bubble.
Then all encoders will be put into a bigger carton to prepare shipment.
Please email us directly or contact online service right now to get the latest video, otherwise you could visit our YOUTUBE page.