|Place of Origin:||Shanghai, China|
|Model Number:||S25 simple rotary encoder|
|Minimum Order Quantity:||1pcs encoder to start order|
|Packaging Details:||each 1 piece was packed into single carton box|
|Delivery Time:||3-5 working days for sample order, 7-15 working days for mass order|
|Payment Terms:||D/A, D/P, T/T, Western Union, Credit Card, Master Card,Paypal, etc|
|Supply Ability:||100K pieces per year|
|Shaft Load:||Radiel: 10N; Axial:5N||Thickness:||30mm|
|Insulation Strength:||AC500V 60s||Encoder Type:||Incremental Encoder|
|Resistance:||10MΩ||Supply voltage:||DC5V; DC8-30V|
|Slew Speed:||5000RPM||Shell Material:||Die Cast Aluminum|
miniature optical encoder,
simple rotary encoder
S25 mini solid encoder axial length 14.5mm diameter 25mm 600ppr for robot
Quick description of S25 rotary encoder
About Encoder Vibration
Vibration acting on an encoder always cause wrong pulse easily.
So we have to pay more attention to encoder working place.
The more pulse per round, the narrower groovy spacing of grating, ore effect to encoder by vibration, when motor speed is low or even stopped, vibration acting on encoder shaft or encoder shell would cause grating vibration, in this way, encoder might show wrong pulse signal.
Product Basis information
|External dimensions||External diameter: 25mm|
|Solid shaft diameter: 4mm(D shape)|
|Encoder type||Incremental encoder|
|Output phase||Phase A,B,Z,A-,B-,Z-|
|Supply voltage||DC5V; DC8-30V|
|Outlet type||Cable out from side|
|Cable out from back|
|Environmental temperature||Operating temperature: -20~+80° (Non icing)|
|Storage temperature: -25~+85° (Non icing)|
|Environmental humanity||Operating and storage: 35~85%RH (non-condensing)|
|Cable length||1M (cable length could be added appropriately by|
|require, but it need payment individually)|
|Consumption current||100mA Max|
|Insulation strength||AC500V 60s|
|Mark to Space ratio||45% to 55%|
|Top response Frequency||100kHz Max|
|Shell Material||die cast aluminum|
|Bearing life||1.5x109 revs at rated load(100000hrs at 2500RPM)|
|Shaft Material||Stainless steel|
ENCODER TECHNOLOGY THEORY
An incremental rotary encoder outputs a certain amount of Pulses per Revolution. The higher this PPR number, the smaller the angle between each pulse. This PPR number is fixed for ordinary incremental encoders. Programmable incremental encoders can adjust this value to a desired number by a software change.
Today most incremental encoders have a Push-Pull (HTL) or RS422 (TTL) output driver, these have replaced most of the older output circuits like Open Collector NPN, Open Collector PNP, Voltage Output.
Push-Pull (HTL) circuits, also known as Totem Pole, provide a signal level which corresponds to the applied supply voltage. The supply voltage typically ranges from 8 to 30 VDC.
With proper connections you can use the Push Pull interface to replace true open collector circuits by using an external diode connected in a way to limit the direction of the current for RS422 (TTL) circuits provide a constant 5 V signal level that is not dependent on the supply voltage. Two supply voltage ranges can be selected: From 4.75 to 5.5 VDC (can be used to replace open collector output drivers) or from 8 to 30 VDC. Using differential signals the output fully complies to the RS422 standard.
Contact Person: Manager