External diameter 130mm hollow shaft encoder up to 65536 high resolution weight 1700g
Encoder type: Incremental encoder
Installation dimension: R72.5mm (spring plate 130T145)
Hollow shaft type: through hole (clamping ring at prior)
Hollow shaft diameter: 48mm, 55mm, 60mm;
Resolution: 1024; 2048; 4096; 8192; 16384; 32768; 65536
Output phase: Phase A+, B+, Z+, A-, B-, Z-
Environmental temperature: Operating:-20 ～+85°；storage:-25 ～+90°
Shell Material: aluminum alloy
About Encoder Vibration
Vibration acting on an encoder always cause wrong pulse easily.
So we have to pay more attention to encoder working place.
The more pulse per round, the narrower groovy spacing of grating, ore effect to encoder by vibration, when motor speed is low or even stopped, vibration acting on encoder shaft or encoder shell would cause grating vibration, in this way, encoder might show wrong pulse signal.
|Encoder type||Incremental encoder|
|Output phase||Phase A+,B+,Z+,A-,B-,Z-|
|Supply voltage||DC5V ; DC8-30V|
|Outlet type||Socket out from side|
|Output mode||Push-pull output|
|line drive (26LS31) TTL|
|line drive(DC8-30V) HTL|
|Consumption current||100mA MAX|
|Top response frequency||300KHZ|
|GND||not connect to encoder|
|Mark to Space ratio||45% to 55%|
|starting torque||less than 300 x 10-3 N.m|
|Intertia moment||less than 220x 10-6kg.m2|
|Shaft load||Radiel 90N; Axial 60N|
A logic gate interprets certain input voltages as high (logic 1) or low (logic 0).
TTL (transistor-transistor-logic): A signal above 2 V is interpreted as logic 1 and a signal less than 0.8 V is interpreted as logic 0. The output voltage ranges between 0-5 V.
HTL (high-threshold-logic): A signal above 3 V is a logic 1 and a signal less than 1 V is a logic 0. The high output signal level is dependent from the supply voltage. Because of the higher voltage difference between logic 0 and 1, the HTL logic is more immune to interference and more resistant against electrical noise.
Mechanical degree is the actual rotation of the shaft in degrees. Electrical degree is used for electrical signals. The required time for completing one alternating voltage/current cycle is defined as 360 electrical degrees (el°). For incremental encoders, one cycle is equal to one complete pulse. With a given PPR the electrical degree can be converted to mechanical degree for any incremental encoder.
1. Goods can shipped via TNT, FedEx, UPS, DHL, EMS, etc.
2. You could select the express according to your requirements if freight collector
3. If you do not have any courier account, we will check and find a cheapest and safety express for you.
4. Our factory has 30% discount with most courier company, so price could be as cheap as possible
1. for 1-10 samples: 3-5 working days
2. for 20-50 mass production: 7-10 working days
3. for over 100pcs, production will be discussed with customers and ship on time
Some Related K130 encoder model number
Each single encoder is packed into a single safe carton with protecting bubble.
Then all encoders will be put into a bigger carton to prepare shipment.