Solid shaft heavy duty encoder S52 rotary encoder ABZUVW phase 2048ppr 4 poles IP66
Simple introduction for S52 rotary encoder
Encoder type: Incremental encoder
External diameter: 51mm
Installation dimension: diameter 40mm
Solid Shaft diameter: 8mm(D shape)
Output phase: Phase A+,B+,Z+,A-,B-,Z-,U+,V+,W+,U-,V-,W-
Supply voltage: DC5V ; DC8-30V
Consumption current: 100mA MAX
Top response frequency: 300KHZ
S52 series encoder Characteristics
|Output phase||Phase A+,B+,Z+,A-,B-,Z-,U+,V+,W+,U-,V-,W-|
|Supply voltage||DC5V ; DC8-30V|
|Outlet type||Cable out from back|
|Socket out from back|
|Cable out from back with socket|
|Consumption current||100mA MAX|
|Shaft Material||Stainless steel|
|Shell Material||die cast aluminum|
|Cable length||1000mm(cable with shielding)|
|Protection grade||IP50 ; IP65|
|Cable length||1M (cable length could be added appropriately by|
|require, but it need payment individually)|
Signal Circuit of encoder
1. The NPN Open Collector -- The NPN Open Collector(NPN) is an interface based on an output circuit with an NPN transistor.
An open collector is the unconnected collector connection of an NPN transistor, whose emitter is connected to earth and whose collector is connected to the output.
2. PNP output
The PNP output is an interface based on an output circuit with a PNP transistor.
3. Push-Pull output(HTL)
High Voltage Transistor Logic functions with a voltage supply in the range 10 and 30 V DC, with 24 V DC being the most usual.
“Low” is defined as an output of between 0 V and 3 V and “high” as between VCC and VCC - 3.5 V.
4. TTL RS-422 output
In a transistor-transistor logic (TTL), both the logical status and the amplification are done by transistors, hence the name.
The TTL output is supplied with either a fixed 5 V voltage or a variable voltage of between 10 and 32 V. For this the low range is defined as the ≤ 0.4 V and the high range as ≥ 2.4 V.
There are plenty of encoder video if you still have any doubts on encoder, please email us directly or contact online service right now.
At the same time, you could also visit our YOUTUBY page easily.
Most of the encoder series have videos for reference.
Matters needing attention
1. Must choose the power supply voltage: DC5V or DC8-30V
2. Must choose leaf spring plate model number if you select hollow shaft encoder
3. Please advise the motor speed (RPM) that you actually use
4. If you have any other requirements, please provide detail parameters