Small optical encoder S30-L series 1024ppr up to 5000rpm aluminum alloy shell solid shaft 4mm diameter 30mm
Feather of S30 series encoder
Encoder type: Incremental encoder
External diameter: 30mm
Shaft diameter: 4mm (D type)
Environmental temperature: Operating temperature: -20~+80° (Non icing)
Protection grade: IP50
Cable length: 1000mm
Principle of encoder
A logic gate interprets certain input voltages as high (logic 1) or low (logic 0).
TTL (transistor-transistor-logic): A signal above 2 V is interpreted as logic 1 and a signal less than 0.8 V is interpreted as logic 0. The output voltage ranges between 0-5 V.
HTL (high-threshold-logic): A signal above 3 V is a logic 1 and a signal less than 1 V is a logic 0. The high output signal level is dependent from the supply voltage. Because of the higher voltage difference between logic 0 and 1, the HTL logic is more immune to interference and more resistant against electrical noise.
Mechanical degree is the actual rotation of the shaft in degrees. Electrical degree is used for electrical signals. The required time for completing one alternating voltage/current cycle is defined as 360 electrical degrees (el°). For incremental encoders, one cycle is equal to one complete pulse. With a given PPR the electrical degree can be converted to mechanical degree for any incremental encoder.
|Encoder type||Incremental encoder|
|Output phase||Phase A,B,Z,A-,B-,Z-|
|Supply voltage||DC5V : DC8-30V|
|Outlet type||Cable out from side|
|Cable out from back|
|Environmental temperature||Operating temperature: -20~+80° (Non icing)|
|Storage temperature: -25~+85° (Non icing)|
|Environmental humanity||Operating and storage: 35~85%RH (non-condensing)|
|Shell||Die cast aluminum|
|Consumption current||100mA Max|
|Shaft Load||Radiel: 10N; Axial:5N|
|Insulation strength||AC500V 60s|
|Mark to Space ratio||45% to 55%|
|Top response Frequency||100kHz Max|
About Our Factory