PC58 Incremental rotary encoder outer diameter 58mm with inner up to 24mm bulit in encoder
|Encoder type||Incremental encoder|
|Hollow shaft type||through hole|
|Hollow shaft diameter||14mm;15mm;19mm;24mm;|
|Output phase||6=A+A-+B+B-+Z+Z-, 6=wire-saving type A+B+Z Lag+U+V+W, 12=A+A-+B+B-+Z+Z-+U+U-+V+V-+W+W-|
|Supply voltage||DC5V ; DC8--30V|
|Outlet type||Radial cable|
|Output mode||Line Driver TTL(DC5V) Less wiring type|
|Line Driver TTL(DC5V); Line Driver HTL(DC8-30V)|
|Consumption current||100mA MAX|
|Top response frenquency||500KHz; 800KHz|
|GND||not connect to encoder, must be effectively connected to GND|
|Starting torque||less than 9.8 x 10-3 N.m|
|Inertia moment||less than 6.5×10-6kg.m2|
|Environmental temperature||Operating:-20 ～+95℃；storage:-25 ～+100℃|
|Enviromental humidity||Operating and storage: 35-85%RH(noncondensing)|
|Net weight||About 100g (with package)|
Principle of encoder
An incremental rotary encoder outputs a certain amount of Pulses per Revolution. The higher this PPR number, the smaller the angle between each pulse. This PPR number is fixed for ordinary incremental encoders. Programmable incremental encoders can adjust this value to a desired number by a software change.
Today most incremental encoders have a Push-Pull (HTL) or RS422 (TTL) output driver, these have replaced most of the older output circuits like Open Collector NPN, Open Collector PNP, Voltage Output.
Push-Pull (HTL) circuits, also known as Totem Pole, provide a signal level which corresponds to the applied supply voltage. The supply voltage typically ranges from 8 to 30 VDC.
With proper connections you can use the Push Pull interface to replace true open collector circuits by using an external diode connected in a way to limit the direction of the current for RS422 (TTL) circuits provide a constant 5 V signal level that is not dependent on the supply voltage. Two supply voltage ranges can be selected: From 4.75 to 5.5 VDC (can be used to replace open collector output drivers) or from 8 to 30 VDC. Using differential signals the output fully complies to the RS422 standard.
1. for 1-10 samples: 3-5 working days
2. for 20-50 mass production: 7-10 working days
3. for over 100pcs, production will be discussed with customers and ship on time
1. T/T, western union, credit card, Paypal, etc
2. 3-5 working days after payment received
3. Encoders will be shipped once ready
Goods can shipped via TNT, FedEx, UPS, DHL, EMS, etc.
You could select the express according to your requirements if freight collector
If you do not have any courier account, we will check and find a cheapest and safety express for you.
Our factory has 30% discount with most courier company, so price could be as cheap as possible.
If you are looking for more information about our factory or about our products, please contact us or email us right now, we will reply you as soon as possible.