Miniature optical encoder K22 hollow shaft encoder diameter of shaft 6.5mm differential output
Quick introduction of K22 encoder
Hollow shaft diameter: 4mm;5mm,6mm,6.5mm
Hollow shaft type: blind hole
Installation dimension: R12mm, spring plate 22T24
Resolution : 250;256;360;400;500;512；720；800；1000;1024；1440;1600
Vibration(endure): Amplitude 0.75mm,10-50Hz,1 hours for three axis individually
Sock(endure): 49m/s2 ,three times for X,Y,Z direction individually
Encoder type: Incremental encoder
Protection grade: IP50
Matters needing attention
1. Must choose the power supply voltage: DC5V or DC8-30V
2. Must choose leaf spring plate model number if you select hollow shaft encoder
3. Please advise the motor speed (RPM) that you actually use
4. If you have any other requirements, please provide detail parameters
K22 incremental encoder Product Information
|Encoder type||Incremental encoder|
|Output phase||Phase A,B,Z|
|Supply voltage||DC5V ; DC8-30V|
|Outlet type||Cable out from side|
|Cable out from back|
|Output mode||Collector open circuit output(NPN &PNP)|
|Consumption current||100mA MAX|
|Top response frequency||300KHZ|
|Rise/ Fall time||1usec Max( 1000mm cable)|
|starting torque||less than 5x 10-4 N.m|
|Intertia moment||less than 1x 10-6kg.m2|
|Shaft load||Radial 2N; Axial 2N|
|Top REV||5000r rpm|
|Environmental temperature||Operating:-20 ～+80°；storage:-25 ～+85°|
|Environmental humidity||Operating and storage: 35-85%RH(noncondensing)|
|Vibration(endure)||Amplitude 0.75mm,10-50Hz,1 hours for three axis individually|
|Sock(endure)||49m/s2 ,three times for X,Y,Z direction individually|
|Shell Material||aluminum alloy|
3-5 working days for sample after full paid
7-15 days for mass production after full paid
Signal Circuit of encoder
1. The NPN Open Collector -- The NPN Open Collector(NPN) is an interface based on an output circuit with an NPN transistor.
An open collector is the unconnected collector connection of an NPN transistor, whose emitter is connected to earth and whose collector is connected to the output.
2. PNP output
The PNP output is an interface based on an output circuit with a PNP transistor.
3. Push-Pull output(HTL)
High Voltage Transistor Logic functions with a voltage supply in the range 10 and 30 V DC, with 24 V DC being the most usual.
“Low” is defined as an output of between 0 V and 3 V and “high” as between VCC and VCC - 3.5 V.
4. TTL RS-422 output
In a transistor-transistor logic (TTL), both the logical status and the amplification are done by transistors, hence the name.
The TTL output is supplied with either a fixed 5 V voltage or a variable voltage of between 10 and 32 V. For this the low range is defined as the ≤ 0.4 V and the high range as ≥ 2.4 V.
There are plenty of encoder video if you still have any doubts on encoder, please email us directly or contact online service right now.
At the same time, you could also visit our YOUTUBY page easily.
Most of the encoder series have videos for reference.